Anthem one (mark two)
The best light in the world just became better. Anthem One's heat sink, electrical contacts, polycarbonate faceplate, rear socket and stainless steel bottom-socket have all been upgraded and enhanced. And as always, Anthem One is military-grade tech. We've dropped Anthem One onto concrete from four feet 100 times and it still works.
Anthem Power (mark two)
Anthem Power (Mark Two) has been massively upgraded to include five-pin DMX512 ports, an OLED interface, USB port for firmware upgrades, improved dimming, reduced fan noise, improved thermal management and Broadway-quality 0-100% dimming.
anthem light cards
At 12mm (.04 inches) thin, 60mm (2.3 inches) square and weighing less then 28 grams (1 ounce), Anthem Light card is unlike any light source on earth. Anthem Light Card lasts up to 50,000 hours, making it the longest lasting light source ever created. Anthem Light Cards can be swapped out of Anthem One in less then 1 minute. As LEDs grow brighter, users can replace their existing Light Cards to increase Anthem One's brightness rather then replace their entire lighting system. At long last, your source of light has more in common with RAM or hard drives than with 19th century glass tubes.
Anthem Light Card's beam is 160 degree at the source. This defies conventional wisdom; it is a massive wall of smooth, pure, punchy light without any modification. The light field behaves more like the sun than any other artificial light source. However, it is effortless to modify. Simply attach one of our magnetic speed mounts with an off-the-shelf grid, fresnel lens, reflector dish or snoot to change the beam diameter. Changing from 160 degrees to 20 degrees only takes 2 seconds. The beam has no hot spot and is perfectly even from edge-to-edge. We've lit a 20 story building, from sidewalk to rooftop, standing on a 14th story balcony 100 feet away. You can comfortably illuminate a half-acre or a 5-story building with a traditional light stand.
Because our visible light cards are made of 900 individual light sources, the beam has off-axis punch and is best visualized as a cone with its tip cut off.
Anthem Light Card's light field is effortless to modify. Simply attach one of our magnetic speed mounts with an off-the-shelf grid, fresnel lens, reflector dish or snoot to change the beam diameter. Changing from 160 degrees to 20 degrees only takes 2 seconds.
Say goodbye to gasoline generators, cable runs, fumes, noise and the large trucks necessary to tow them. Lithium-ion is here...and Anthem One is the most electrically efficient high-output light on earth.
With batteries, every lumen-per-watt counts.
Anthem Thermal Paste
Anthem Thermal Paste is odorless, non-volatile, non-corrosive, non-toxic, flame retardant and not electrically conductive. Each syringe of thermal paste contains approximately two grams (approximately five applications).
Applying Anthem Thermal Paste is simple. Remove the front four screws surrounding Anthem Light Card. If thermal paste is moist, then no re-application of thermal paste is necessary. If the thermal paste is dry and flakey, wipe clean with a wet wipe and apply two rice-grains in the center of the heat sink.